Release Tension Torsion Spring Garage Door

It is important to understand that the springs used in opening and closing a garage door support the entire weight of the garage door.

Release tension torsion spring garage door.

There are two torsion springs at each side of the garage door. The torsion spring helps the garage door open and close easily. You must release the tension on the garage door springs before attempting adjustment or replacement. Hold the garage door in this position by attaching a c clamp to the track at a point below the lowest door roller wheel.

This means that there is extreme tension in these springs and that any sudden and uncontrolled release of these springs is dangerous and could cause serious injuries. A problem with the spring tension could cause the door to open or close unevenly improperly or at the wrong speed and adjusting the springs will likely solve the problem. The springs are located at the top inside part of the garage door. You need these to remove tension from the existing springs at the beginning of the project and add the proper tension to the replacement torsion springs at the end.

Two winding bars. Dura lift 0 207 in x 2 in left and right wound 2 pack yellow steel garage door torsion spring. If the garage door isn t opening or closing properly then check the tension on the torsion springs for needed adjustments. This is accomplished by opening the garage door as fully as possible until it hits the stop bolt on the track.

Sectional doors and hinged doors are adjusted using a basic procedure for. Garage door springs offset the weight of the door and allow it to open and close with ease. Place a winding bar in one of the holes. Dura lift 0 218 in x 2 in left and right wound 2 pack white steel garage door torsion spring.

For pricing and availability. Here are the tools you need to replace a broken garage door torsion spring. Both the winding and stationary cones are professionally installed for safe operation. Install new or use this pair of left install new or use this pair of left and right wound torsion springs to replace broken sectional garage door torsion springs.